how to pair Kimfly

How to pair kimfly?

So you’ve purchased another Kimfly Key Finder? Congrats! This is a cost-effective and simple method of ensuring that you never lose your keys again.

Sadly, the instructions for how to pair Kimfly Key Finder are a little light. But rest assured! We’ll fill in the gaps and make it simple to pair your Kimfly Key Finder with Bluetooth in this section.

Naturally, you will need batteries in order to pair your Kimfly Key Finder! Take note that a portion of the initial pairing procedure that must be completed on the Kimfly device itself is covered in these instructions as well.

How to Install Batteries in a Kimfly

Open the “snap gap” on the top covers first.

Next, press the battery and install it with the negative pole facing down, as shown below. Finally, secure the battery’s housing.

For the Kimfly to be registered, select the “device” icon. Next, press and hold the camera button. After two beeps, it should register on its own. To finish the registration, click the “+” icon in the upper right corner.

How to Finish Pairing Your Kimfly

After installing the battery and finishing the hardware steps, you can register your Kimfly to finish pairing it.

You must install their app before you can register your Kimfly. This can be accomplished by searching for “IKON” in the app store or by scanning the QR code on the box. This is NOT the app for ski passes.

After installing the Kimfly app, turn on the Bluetooth on your phone and launch the IKON app.

After that, your Kimfly device should appear in the app, where you can register it and give it whatever name you want.

You should be able to see the Kimfly wherever it is after registering it.

That’s it, then! You now know how to pair Kimfly Key Finder and insert batteries, ensuring that you will never again lose your keys. Enjoy!

If you found this article helpful, don’t forget to browse the other articles on this page 5elifestyle!

Leave a comment

Your email address will not be published. Required fields are marked *

%d bloggers like this: